Pass Through
24 to 26AWG
Plug assembly can be time-consuming and difficult. Conventional assembly process – line up the wires and trim flush, insert the wires until they reach the end wall of the plug… In reality, the wires often get kinked or slack despite how fantastic everything seems to be. The kink and slack could jeopardize the conductivity and worsen the transmission performance.
A pass-through plug may be a tremendous aid because it allows threading the wires through the end wall and then cutting in sequence. It greatly increases job efficiency and reduces continuity-failure rates. Works with 007A8ST014 Series Crimping Tool. Wire termination and cutting at the same time.
The 8-position groove inside the plug housing is 1.0mm+0.02/-0mm wide and the entrance accepts cable sizes smaller than 6.5mm. The 3-prong blades enhance the certainty of piercing both the solid and the stranded cable so excellent conductivity can be assured.
Exceeds TIA-568.2-D and ISO/IEC 11801 Cat 6 transmission standards.